Bosch Rexroth A2FM series - Dimensions sizes 80, 90; Shaft options; Ports

Bosch Rexroth AG, RE 91001-01-X-B2/01.2016
18 A2FM for explosive areas | Axial piston fixed motor
Dimensions sizes 80, 90
Dimensions [mm]
Dimensions sizes 80, 90
T
1
T
2
A B
45°
45°
165
165
13.5
180
ø138
41
132
20
32
1)
10
ø140
–0.025
29
63
40°
83
Flange
ISO3019‑2
▼ Splined shaft DIN 5480,
NG80, 90
▼ Splined shaft DIN 5480,
NG80
▼ Parallel keyed shaft, DIN 6885,
NG80, 90
▼ Parallel keyed shaft, DIN 6885,
NG80
A – W40×2×18×9g
Z – W35×2×16×9g B – AS12×8×56 P – AS10×8×56
45
37
M16 × 2
2)3)
⌀45
12
36
40
32
M12 × 1.75
2)3)
⌀45
9.5
28
43
70
M16 × 2
2)3)
⌀45
⌀40
+0.018 +0.002
12
36
Key width 12
38
70
M12 × 1.75
2)3)
⌀45
⌀35
+0.018 +0.002
9.5
28
Key width 10
Ports Standard Size
3)
p
maxabs
[bar]
4)
State
7)
A, B Working port (see subplates, page 19) 450
T
1
Drain port DIN 3852
6)
M18 × 1.5; 12 deep 3 X
5)
T
2
Drain port DIN 3852
6)
M18 × 1.5; 12 deep 3 O
5)
1) To shaft collar
2) Center bore according to DIN332 (thread according to DIN13)
3) For notes on tightening torques, see the instruction manual.
4) Depending on the application, momentary pressure peaks may occur.
Keep this in mind when selecting measuring devices and fittings.
5) Depending on installation position, T
1
or T
2
must be connected
(see also installation instructions on page 27).
6) The spot face can be deeper than as specified in the standard
7) O= Must be connected (plugged on delivery)
X= Plugged (in normal operation)