Bosch Rexroth A2FM series - Location of working ports on port plates

RE 91001-01-X-B2/01.2016, Bosch Rexroth AG
Axial piston fixed motor | A2FM for explosive areas
Dimensions sizes 80, 90
19
Dimensions [mm]
▼ Location of working ports on port plates
010 – SAE flange connections A and B at rear 020 – SAE flange connections A and B on side, opposite
AB
27.8
166
57.2
25
84
233
144
203
104
Y
AB
Y
196
99
257
162
160
57.2
25
27.8
100 – SAE flange connections A and B below (same side)
A
B
Y
27.8
84
57.2
25
166
236
121
206
145
60
Plate Ports Standard Size
1)
p
maxabs
[bar]
2)
State
6)
010, 020,
100
A, B Working port
Fastening thread A/B
SAE J518
3)
DIN 13
1 in
M12 × 1.75; 17 deep
450 O
Subplate 188 see Page 26.
1) For notes on tightening torques, see the instruction manual.
2) Depending on the application, momentary pressure peaks may occur.
Keep this in mind when selecting measuring devices and fittings.
3) Only dimensions according to SAE J518, metric fastening thread is
a deviation from the standard.
4) O= Must be connected (plugged on delivery)
X= Plugged (in normal operation)