Bosch Rexroth A2FM series - Dimensions, sizes 10, 12, 16; Shaft options; Ports

Bosch Rexroth AG, RE 91001-01-X-B2/01.2016
10 A2FM for explosive areas | Axial piston fixed motor
Dimensions, sizes 10, 12, 16
Dimensions [mm]
Dimensions, sizes 10, 12, 16
T
1
T
2
A B
45°
45°
20
1)
⌀80
–0.019
12
29
⌀85
95
18.2
60
95
95
6
54
9
100
40°
Flange
similar to ISO 3019‑2
▼ Splined shaft DIN 5480,
NG10, 12, 16
▼ Splined shaft DIN 5480,
NG10, 12
▼ Parallel keyed shaft, DIN 6885
NG10, 12, 16
▼ Parallel keyed shaft, DIN 6885,
NG10, 12
A – W25×1.25×18×9g
Z – W20×1.25×14×9g B – AS8×7×32 P – AS6×6×32
28
22
M10 × 1.5
2)3)
⌀28
7.5
22
34
22
M6 × 1
2)3)
⌀28
5
16
28
40
M10 × 1.5
2)3)
⌀28
⌀25
+0.015 +0.002
7.5
22
Key width 8
22.5
40
M6 × 1
2)3)
⌀28
⌀20
+0.015 +0.002
5
16
Key width 6
Ports Standard Size
3)
p
maxabs
[bar]
4)
State
7)
A, B Working port (see subplates, page 11) 450
T
1
Drain port DIN 3852
6)
M12 × 1.5; 12 deep 3 X
5)
T
2
Drain port DIN 3852
6)
M12 × 1.5; 12 deep 3 O
5)
1) To shaft collar
2) Center bore according to DIN332 (thread according to DIN13)
3) For notes on tightening torques, see the instruction manual.
4) Depending on the application, momentary pressure peaks may occur.
Keep this in mind when selecting measuring devices and fittings.
5) Depending on installation position, T
1
or T
2
must be connected
(see also installation instructions on page 27).
6) The spot face can be deeper than as specified in the standard
7) O= Must be connected (plugged on delivery)
X= Plugged (in normal operation)