Bosch Rexroth A2FM series - Location of working ports on port plates

RE 91001-01-X-B2/01.2016, Bosch Rexroth AG
Axial piston fixed motor | A2FM for explosive areas
Dimensions sizes 56, 63
17
Dimensions [mm]
▼ Location of working ports on port plates
010 – SAE flange connections A and B at rear 020 – SAE flange connections A and B on side, opposite
AB
19
23.8
147
50.8
206
130
75
182
96
Y
AB
Y
136
225
142
87
171
23.8
50.8
19
040 – threaded connections A and B on side and at rear 100 – SAE flange connections A and B below (same side)
AB
Y
136
149
225
142
87
171
58
195
107
A
B
Y
23.8
75
50.8
19
147
49
206
130
182
107
Plate Ports Standard Size
1)
p
maxabs
[bar]
2)
State
6)
010, 020,
100
A, B Working port
Fastening thread A/B
SAE J518
3)
DIN 13
3/4 in
M10 × 1.5; 17 deep
450 O
040 A, B Working port DIN 3852
4)
M33 × 2; 18 deep 450 each 1 × O
Subplate 188 see Page 26.
1) For notes on tightening torques, see the instruction manual.
2) Depending on the application, momentary pressure peaks may occur.
Keep this in mind when selecting measuring devices and fittings.
3) Only dimensions according to SAE J518, metric fastening thread is
a deviation from the standard.
4) The spot face can be deeper than as specified in the standard
5) O= Must be connected (plugged on delivery)
X= Plugged (in normal operation)