Bosch Rexroth A2FM series - Location of working ports on port plates

RE 91001-01-X-B2/01.2016, Bosch Rexroth AG
Axial piston fixed motor | A2FM for explosive areas
Dimensions size 45
15
Dimensions [mm]
▼ Location of working ports on port plates
010 – SAE flange connections A and B at rear 020 – SAE flange connections A and B on side, opposite
AB
Y
19
75
23.8
147
50.8
194
122
166
89
AB
Y
155
207
80
133
19
50.8
128
23.8
040 – threaded connections A and B on side and at rear 100 – SAE flange connections A and B below (same side)
AB
Y
128
141
207
133
155
80
58
179
100
A
B
Y
193
119
102
169
23.8
75
50.8
19
147
49
Plate Ports Standard Size
1)
p
maxabs
[bar]
2)
State
6)
010, 020,
100
A, B Working port
Fastening thread A/B
SAE J518
3)
DIN 13
3/4 in
M10 × 1.5; 17 deep
450 O
040 A, B Working port DIN 3852
4)
M33 × 2; 18 deep 450 each 1 × O
Subplate 188 see Page 26.
1) For notes on tightening torques, see the instruction manual.
2) Depending on the application, momentary pressure peaks may occur.
Keep this in mind when selecting measuring devices and fittings.
3) Only dimensions according to SAE J518, metric fastening thread is
a deviation from the standard.
4) The spot face can be deeper than as specified in the standard
5) O= Must be connected (plugged on delivery)
X= Plugged (in normal operation)