Bosch Rexroth A2FM series - Location of working ports on port plates

RE 91001-01-X-B2/01.2016, Bosch Rexroth AG
Axial piston fixed motor | A2FM for explosive areas
Dimensions, sizes 23, 28, 32
13
Dimensions [mm]
▼ Location of working ports on port plates
010 – SAE flange connections A and B at rear 020 – SAE flange connections A and B on side, opposite
AB
Y
13
18.2
115
40.5
173
106
59
153
78
AB
Y
120
144
117
190
70
18.2
40.5
13
030 – threaded connections A and B on side, opposite 040 – threaded connections A and B on side and at rear
AB
Y
144
117
190
70
120
AB
Y
144
117
190
70
58
120
130
166
88
100 – SAE flange connections A and B below (same side)
4)
A
B
Y
158
106
91
178
13
18.2
115
40.5
59
40
Plate Ports Standard Size
1)
p
maxabs
[bar]
2)
State
6)
010, 020,
100
A, B Working port
Fastening thread A/B
SAE J518
3)
DIN 13
1/2 in
M8 × 1.25; 15 deep
450 O
030 A, B Working port DIN 3852
5)
M27 × 2; 16 deep 450 O
040 A, B Working port DIN 3852
5)
M27 × 2; 16 deep 450 each 1 × O
Subplate 188 see Page 26.
1) For notes on tightening torques, see the instruction manual.
2) Depending on the application, momentary pressure peaks may occur.
Keep this in mind when selecting measuring devices and fittings.
3) Only dimensions according to SAE J518, metric fastening thread is
a deviation from the standard.
4) Only sizes 28 and 32
5) The spot face can be deeper than as specified in the standard
6) O= Must be connected (plugged on delivery)
X= Plugged (in normal operation)