Bosch Rexroth EC 3500+ - Product-specific safety instructions; Personal protective equipment

10/24 4THE5 | Safety instructions
Bosch Rexroth AG, RE29696-01-B/2021-06-15
2�6 Product-specific safety instructions
The following safety instructions apply to chapters 6 to 14.
WARNING
System/machine under pressure!
Risk of death or serious injury when working on unsecured machines/systems!
Property damage!
▶ Switch off the relevant machine/system part and secure it against reactivation
according to the parameters by the machine/system manufacturer.
▶ Ensure that all relevant components of the hydraulic system are depressurized.
For this purpose, observe the parameters indicated by the machine/system
manufacturer.
▶ Please note that the hydraulic system might still be pressurized even after
separation from the actual pressure supply.
▶ Do not diskonnect any line connections, ports and components as long as the
hydraulic system is under pressure.
Electrical voltage!
Danger tolife orrisk ofinjury due toelectric shock orproperty damage!
▶ Always disconnect the voltage supply tothe relevant machine/system
part before installing the product and/or connecting ordisconnecting the
connector.
▶ Protect themachine/system against being re-energized.
CAUTION
Improper cable and line routing!
Risk of stumbling and property damage! Improper routing of cables and lines
can cause arisk of stumbling as well as damage to equipment and components,
e.g.due to lines and connectors being torn off.
▶ Always install cables and lines in away that nobody can fall over them, that
they are not bend or twisted, do not chafe on edges and are not guided
through ducts with sharp edges without sufficient protection.
Danger due to malfunctions!
Risk of injury and property damage as well as machine damage due to
malfunctions of the joystick!
▶ Carry out arisk assessment of your machine and determine the possible
safety-relevant functions.
▶ Take suitable measures to ensure safety in applications relevant to safety,
e.g.joystick redundancy, plausibility check, emergency switch, etc.
▶ Product data that is required for the safety assessment of the machine is
included in datasheet 29696/29697.
2�7 Personal protective equipment
The personal protective equipment is the responsibility of the user of the product.
Observe the safety regulations in your country.
All pieces of personal protective equipment should be intact.