Bosch Rexroth EC 3500+ - General instructions on property damage and product damage

RE29696-01-B/2021-06-15, Bosch Rexroth AG
General instructions on property damage and product damage | 4THE5 11/24
3 General instructions on property
damage and product damage
The following notices apply to chapters 6 to 14.
NOTICE
Danger from improper handling!
Product can bedamaged!
▶ Do not expose the product toany mechanical, hydraulic orelectric loads
under any circumstances.
▶ Never use theproduct asstep.
▶ Do not put/place any objects onthe product.
▶ Do not use sensitive assembled parts (e.g. harness or connector) for
transporting the joystick.
▶ Carefully place the joystick onto the contact surface to prevent it from being
damaged and secure it against falling.
▶ Do not set/place the joystick onto the actuation elements.
▶ Do not hit sensitive assembled parts (e.g.actuation elements).
▶ Do not hit sealing surfaces (e.g. onthe work ports).
▶ Leave the protective covers on the joystick until you connect the lines.
▶ Disconnect all electric connectors before any painting or soldering operations
on the machine.
▶ Ensure that the electronic components (e.g.sensors) are not electro-statically
charged (e.g.during painting operations).
Improper cleaning
Product can bedamaged!
▶ Plug all openings with appropriate protective equipment to prevent cleaning
agents from entering the joystick.
▶ Never use solvents oraggressive cleaning agents. Clean the joystick using only
water and a plastic cleaning agent if necessary.
▶ Do not direct the high-pressure cleaner tosensitive components, e.g.joystick
base, rubber parts (bellows), electric connections (solenoids, sensors) and
actuation elements.
▶ Use fibre-free cleaning cloths forcleaning.
Environmental pollution due to incorrect disposal!
Careless disposal of the product and the packaging material could lead to
environmental pollution!
▶ Dispose of the product and packaging in accordance with the national
regulations in your country.
Electrical voltage!
Damage to property due to electrical voltage!
▶ Always disconnect the voltage supply to the relevant machine/system
part before installing the product and/or connecting or disconnecting the
connector. Protect the machine/system against being re-energized.
▶ Do not touch the connector pins with a tool or fingers for ESD reasons.
The warranty exclusively applies to the delivered configuration.
The warranty will be voided if the product is incorrectly installed, commissioned or
operated, or if it is used or handled improperly.