Extension Module Mounting
Extension module mounting
1. Remove 2-M3 screws ① on back of the extension card
module.
2. Remove the front cover of the extension card module.
3. Insert one extension card into the card slot with the
metal plate beside the extension card terminals placed
in ②.
4. Push the extesion card to achieve a stable connection of
connector ③ (on the back side of the extesion card)
with connector ④ (on the extension card module).
5. Mount the front cover of the extension card module.
6. Tighten 2-M3 screws ① of the extension card module.
7. Attach an appropriate terminal label on the label inden-
tation ⑤ located at the lower section of the front cover.
Terminal labels for various extension cards are delivered
together with each extension card.
Terminal labels of extension cards
▶ Maximum two extension cards can be moun-
ted in one extension card module.
▶ Extension cards in the two card slots CAN-
NOT be the same.
▶ ONLY ONE type of communication card can
be mounted in one extension card module.
Rexroth Frequency Converter
EFC x610 / VFC x610
Extension Module and Extension Card Module
Mounting Instructions
R912006261
Edition 01
DOK-RCON0*-XFC-X610***-AS01-EN-P, R912006261, Edition 01, Bosch Rexroth AG
To Next Page
Need help?
General
