22
/88
Bosch Rexroth AG LTS350D/LTE350D
| 3 608 870 0D6/2011-12
Display
The graphic LC display (Figure 2) enables a
display of the result values (torque, angle,
gradient, time) and error codes. Texts are
shown in 4 lines, each with 8 characters. The
display is permanently backlit (LED).
The contrast can be adjusted in the BS350
operating system, if necessary.
Fig. 2: LC display
Display
The inverse display shows:
– Error
–NOK.
Tab. 1
Target function Actual value
Upper torque T
Lower torque TI
Relative torque, upper T&
Relative torque, lower TI&
Angle A
Input IN
Time t
Yield point Yp
Gradient G
Tab. 2
Monitoring function Actual value
Torque T
Relative torque T&
Torque max. value T>
Torque min. value T<
Torque average value TA
Torque range T[
Redundancy torque TR
Tightening from above TCh
Tightening from below TCl
Angle A
Total angle AO
Redundancy angle AR
Gradient G
Gradient average value GA
Time t
Stick slip STS
Yield point Yp
Tab. 3
Function Actual
value
Displays
Yes/No
Total time to Yes
Tab. 4
Event Marking
Remove start
signal
C(c)w 0
System error Fault
To Next Page
Loading...
