28
/88
Bosch Rexroth AG LTS350D/LTE350D
| 3 608 870 0D6/2011-12
11 Disassembly and
replacement
Required tools
• Screwdriver (size 0.8 x 4.5 mm)
Disassembling
Proceed as follows to disassemble the
LTS350D/LTE350D servo amplifiers:
1. Switch off the power supply for the
BT356 card rack or SB35x system box
and allow for a discharging time of
10 seconds.
2. Loosen the knurled screws on the front
panel and pull out the LTS350D/
LTE350D servo amplifier.
3. If necessary, assemble a BP 351 dummy
panel, order number 3 608 878 058.
12 Disposal
Environmental protection
Careless disposal of the LTS350D/LTE350D
servo amplifiers could lead to pollution of the
environment.
Therefore, dispose of the device in accord-
ance with the currently applicable regulations
in your country.
You can also send the device to Bosch
Rexroth for disposal.
13 Extension and conver-
sion
The LTS350D/LTE350D servo amplifiers
must not be converted.
14 Troubleshooting
Malfunctions and information on errors are
displayed:
• on the display (see section “Display” on
page 22)
• by the LED on the front (see section “LED
display and reset button” on page 22)
• in the tightening system via the BS350.
Should you be unable to remedy an occurring
defect, please contact one of the addresses
found under www.boschrexroth.com or in the
address directory in chapter “16 Service and
sales” on page 30.
CAUTION
Removing the LTS350D/LTE350D
servo amplifiers under voltage
Damage at the LTS350D/LTE350D servo
amplifiers!
Always switch off the power supply for
the relevant system component before
disassembling the LTS350D/LTE350D
servo amplifiers.
For safety reasons, the LTS350D/
LTE350D servo amplifier may only be
inserted or removed at the earliest 10
seconds after the power supply to the
BT356 card rack or SB35x system box
has been switched off.
To Next Page
Loading...
