1−12 Electric Drives
and Controls
Bosch Rexroth AG BT 6.00 1070080078 / 03
Safety Instructions
1.11 Safe working practices
DANGER
Program start is immediately possible after fault reset!
If the start signal is present when an error is reset (acknowledged),
the timer will start its program run immediately! This may result in
dangerous machine movements!
Therefore, prior to error-reset, make sure that there is no-one in
the hazard area of the welding equipment!
DANGER
Danger of welding splashes!
Welding splashes have to be expected during operation of the
welding plant! This may result in eye injuries and burns. Therefore
− wear protective goggles
− wear safety gloves
− wear flame-retardant clothes
DANGER
Danger of injuries at sharp metal edges and danger of getting
burnt by hot welded parts!
Therefore, you should wear safety gloves.
CAUTION
Strong magnetic fields!
The strong magnetic fields occurring in the resistance welding
process may cause permanent damage to wrist watches, pocket
watches, or cards with magnetic stripes (e.g. EC cards).
Therefore, you should not carry any such items on you when work-
ing in the immediate vicinity of the welding equipment.
To Next Page
Loading...
