Electric Drives
and Controls
1−1Bosch Rexroth AGBT 6.001070080078 / 03
Safety Instructions
1 Safety Instructions
The products described were developed, manufactured, documented
and tested in compliance with the fundamental safety requirements of
the EU machinery directive. These products normally pose no danger to
persons or property if used in accordance with the handling stipulations
and safety notes prescribed for their configuration, mounting, and proper
operation.
Nevertheless, there is some residual risk!
Therefore, you should read this manual before installing, connecting or
commissioning the products or programming the welding system.
Store this manual in a place to which all users have access at any time.
The contents of this manual refer to
D the mechanical structure
D the electrical connection and
D the functionality
of the control and diagnostic terminal
− BT 6.00 (built-in unit) and
− BT 6.00 HPG (manual programming terminal).
For the actual weld timers, please refer to the other manuals pub-
lished. They supplement the present manual!
1.1 Possible Safety Markings on the Product
Warning of dangerous electrical voltage!
Warning of hazards associated with batteries!
Electrostatically sensitive components!
Lug for connecting PE conductor only!
Function ground, ground with low parasitic voltage
Connection of shield conductor only
To Next Page
Loading...
