Bosch Rexroth RA2-1/10 - Page 25

RE95230-B/2021-12-01, BoschRexrothAG
Installation | Analog amplifier RA 25/48
max. 12cm
Fig� 13: Lead the wires away in alight bend
– Ensure correct stripping length (4mm) and correct crimping
(see TE Connectivity documents 114-18022 and 114-18050).
Wire protruding max. 1mm
Insulation crimped
Insulation not crimped
Correct crimping
Incorrect crimping
Hook
Fig� 14: Correct stripping length
– The catch of the contact must be engaged in the detent locking of the contact
carrier.
Verify this by pulling on the line (tensile test).
– Immediately consider internal bridges and - if necessary - wiring elements
(resistance) in the connector and install them according to the following
instructions.