11
B O S C H
Trouble shooting
Problem Probable cause Solution
The iron does not
heat up.
The “SensorSecure” function
has been activated. The iron
is set to stand-by.
Grip the handle of the iron to
re-start it.
Water drips out of the
soleplate when using
the “shot of steam”
function.
You have pressed the shot of
steam button (4) repeatedly
without waiting for 5 seconds
between each press.
Wait 5 seconds between each
press of the shot of steam
button.
Steam does not come
out.
Steam regulator (5 ) is set to
position.
Set the steam regulator to a
higher position.
Excessive dripping or
steaming.
No proper closing of “clean”
button (9).
Point the iron away from the
ironing area. Actuate a few times
the “clean” button.
Smoke comes out
when connecting the
iron for the rst time.
This may be caused by the
lubrication of some of the
internal parts.
This is normal and will stop after
a few minutes.
Deposits come out
through the holes in
the soleplate (10).
Traces of lime scale are
coming out of the steam
chamber.
Carry out a cleaning cycle (see
“Calc'nClean function” section).
If none of the above solves the problem, get in touch with
an Authorised Technical Service.
Guarantee conditions
The terms of the guarantee for this
appliance are in accordance with that
stated by our representative for the country
in which it is sold.
The details of these conditions can be
obtained from the retailer from whom the
appliance was purchased. The purchase
receipt must be presented when making
any claims against the terms of this
guarantee.
To Next Page
Loading...
