5
B O S C H
Description
1. "TempOK" indicator lamps
2. “SensorSecure” indicator lamp
3. Spray button
4. Shot of steam button
5. Steam regulator
6. Water inlet lid
7. Spray nozzle
8. Level mark for maximum lling
9. “clean” button
10. Soleplate
11. Heel
12. Power cable
Using your appliance
1. Filling the water tank
This appliance has been designed to use normal tap water.
Important: Do not use additives! The addition of other
liquids, such as perfume, vinegar, starch, condensation
water from tumble dryers or from air conditioning systems
or chemicals will damage the appliance. Any damage
caused by the use of the aforementioned products will
make the guarantee void!
1 Unplug the iron from the mains.
2 Set the steam regulator (5) to the position .
3 Open the water inlet lid (6).
4 Fill the water tank. Never ll beyond the level mark
for maximum lling (8)!
5 Close the water inlet lid.
Tip: To prolong the optimum steam function, you may mix
tap water with distilled water 1:1. If the tap water in your
district is very hard, mix tap water with distilled water 1:2.
45º
To Next Page
Loading...
