NL Set up and connect
Drinking water connection
Connect the device to a drinking
water connection.
Install drinking water connection
Note When you replace the
appliance, you must use a new
water inlet hose.
1. The necessary steps can be found in
the supplied installation manual.
2. Connect the device to the
drinking water connection using
the enclosed parts.
The technical data
→
Page 59
consider.
3. Make sure that the drinking water
connection is not kinked, crushed
or entangled.
Electrical connection
Connect the device to the mains.
Connecting the appliance
electrically Notes
s Take the safety precautions
→
Page 5
heed.
s Only connect the device
on an AC voltage of 220 - 240 V
and 50 Hz or 60 Hz.
s Please note that the
The protection system only works
when the device is supplied with
power.
1. Connect the appliance plug of the
connecting cable to the appliance.
2. Plug the appliance into a socket in
the vicinity of the appliance.
The connection data of the device
can be found on the type plate.
3. Check the plug for tightness.
16
To Next Page
Loading...
