NL Troubleshooting
Malfunctions
Faults Cause Solution
There will remain after the Sieve system or space below 1.
2.
Clean the strainers → Page 42.
program water in the
appliance.
the sieve is clogged.
Clean the drain pump
→Page 56.
Program has not yet
ended.
▶
Wait for the end of the program or
cancel the program with Reset.
▶
→"Abort program",
Page 39
Device cannot be
switched on or operated.
Device functions
have failed.
1. Unplug the appliance from the
mains socket or switch off the
fuse.
2.
3.
Wait at least 2 minutes.
Connect the device to
the mains.
4. Switch on the device.
The device does not start. Fuse of the house
installation is not OK.
▶
Check the fuse of the house
installation.
Power cord is not
connected.
1.
2.
Check that the socket is
working.
Check whether the connecting cable is
properly connected to the mains
socket and to the rear of the
appliance.
Appliance door is not
completely closed.
▶
▶
Close the appliance door.
Program starts
automatically.
The program has not
ended.
→"Abort program",
Page 39
Device hangs in a
program or cuts out.
Appliance door is not
completely closed.
▶
Close the appliance door.
Power and/or water supply
is interrupted.
1.
2.
Check the power supply.
Check the water supply.
The upper basket presses
against the inner door and
prevents the appliance door
from closing properly.
▶
Check whether the rear wall
of the device is pressed in by
a socket or non-
disassembled hose holder.
▶
Arrange the crockery in such a way
that no crockery parts protrude over
the crockery basket and prevent the
appliance door from closing properly.
54
To Next Page
Loading...
