NL Basic settings
B Basic settingsasis settings
You can set up your device according to your needs.
Overview of the basic settings
The basic settings depend on the equipment of your appliance.
Basic setting Display text Choise Description
Water hardness H:04 1 H:00 - H:07 Set the water softener to the water
hardness.
→"Setting water softening",
Page 29
At position H:00 the water
softening is switched off.
rinse aid
lilac
r:05 1 r:00 - r:06 Set the amount of rinse aid.
→"Amount of rinse aid
set", page 32
Switch off the rinse aid
with position r:00.
Intensive drying d:00 1 d:00 - d:01 During the final rinse, the temperature
is increased, which results in better
drying results. As a result, the run time
may increase slightly.
Note Not suitable for
delicate items of crockery.
Switch on intensive drying "d:01"
or switch off "d:00".
hot water A:00 1 A:00 - A:01 Set cold water connection or hot
water connection. Only set the
device to Hot water if the hot water
is prepared in an energetically
favorable way and a suitable
installation is available, eg a solar
boiler with circulation pipe. The
water temperature must be a
minimum of 40 °C and a maximum
of 60 °C. Switch on hot water
"A:01" or switch off "A:00".
1 Factory setting (may differ depending on the device type)
Change basic settings
2. press and hold
Pine tree.
1. on to press.
40
To Next Page
Loading...
