NL Troubleshooting
Faults Cause Solution
There are removable
smudges on glasses,
glassware with a metallic
appearance and cutlery.
Residual detergent is
present during the
rinse cycle part of the
program. Detergent
dispenser lid was
blocked by dishes and
did not open fully.
1. Arrange the dishes in the
upper basket in such a way
that the tablet tray is not
blocked by dishes.
→"Clearing crockery",
Page 36
Pieces of crockery are blocking
the lid of the detergent dispenser.
2. Do not place crockery or fragrance
dispenser in the tablet container.
Crockery has been pre-
cleaned too well. The sensor
system therefore opts for a
weak washing program.
Stubborn dirt can
▶ Only remove coarse food residues
and do not pre-rinse the dishes.
▶ Adjust the sensitivity of the sensor
system on.
not be removed at all.
Irreparable glass
clouding.
Glasses are not
dishwasher safe, but
only suitable for
dishwasher.
▶ Use dishwasher safe
your glasses.
▶ Avoid a long steam phase
(standing time) at the end of the wash
cycle.
▶ Use a program with a
lower temperature.
▶ Set the water softening to the
water hardness.
▶ Use a detergent with
glass protection components.
Rust traces on the cutlery. Cutlery is not enough
▶ Use rust-resistant cutlery.
rust resistant. Knife
blades are often more
affected by this.
Cutlery also rusts
when washed with
rusty objects.
▶ Do not wash rusting objects
off.
Salt content in the washing
water is too high.
1. Remove spilled softening salt from
the rinse aid container.
2. Tightly close the lid of the
softening salt reservoir.
52
To Next Page
Loading...
