Location 900
Default Options
Location 901 - 904
System Time
Location 905 - 910
System Date
Solution Ultima RF Receiver Interface Connections
Figure 1: RF Receiver (RF3212) Wiring Diagram
Wiring and Power Up Operation
- Remove power from the control panel. The following describes the status of the module based on the LED
condition.
- Connect the RF Receiver to the control panel as shown
above using 0.8mm (22-gauge) or larger wire. Wire length
should not exceed 300 meters (1000 feet).
LED On
– Module is functioning normally.
LED Off
– Power failure has occurred or module is not wired
correctly.
- Apply power to the control panel. The red LED at the centre
of the module will turn on.
LED Turns Off Momentarily – Module acknowledged receiving an
RF signal from a remote RF device.
RF Keyfob Operations For Solution Ultima Series Control Panels
Figure 2: RF3332 - 2 Button RF Keyfob Figure 3: RF3332 - 2 Button RF Keyfob
0
0 = Defaulting System Allowed / 15 = Defaulting System Disabled
Location 901 = Hour Of The Day (Tens Digit)
Location 902 = Hour Of The Day (Units Digit)
Location 903 = Minute Of The Day (Tens Digit)
Location 904 = Minute Of The Day (Units Digit)
901 902 903 904
0 0 : 0 0
H H M M
Location 905 = Day Of The Month (Tens Digit)
Location 906 = Day Of The Month (Units Digit)
Location 907 = Month Of The Year (Tens Digit)
Location 908 = Month Of The Year (Units Digit)
Location 909 = Current Year (Tens Digit)
Location 910 = Current Year (Units Digit)
905 906 907 908 909 910
0 1 0 1 0 1
D D M M Y Y
Solution Ultima 880
Quick Reference Guide
19
Bosch Security Systems Pty Limited
To Next Page
Loading...
