Bosch Solution Ultima 880 - Isolating Zones

Arming The System (On)
AWAY Mode
1. Pres
s and hold the # key until two beeps are
heard.
Or
2. Enter your code followed by the # key.
[eg. 2580 + #].
S
TAY Mo
de 1
1.
Press and hold the * key until tw
o beeps are
heard.
Or
2.
Enter your code followed by the * key.
[
eg. 2580 + *].
S
TAY Mo
de 2
1. Pres
s and hold the 0 key until two beeps are
heard.
A
rm All A
reas In AWAY Mode
1. Enter your code followed by 0 and then the #
k
ey [eg. 2580 + 0 + #].
This function allows a code to arm all areas that the
code i
s assigned to in AWAY Mode at the same time
without the need to arm each area individually.
Disarming The System (Off)
AWAY Mode
1. Enter your code followed by the # key.
[eg. 2580 + #].
S
TAY Mo
de 1
1. Press and hold the * key until tw
o beeps are
heard (Only if no alarm).
Or
2. Enter your code followed by the # key.
[eg. 2580 + #].
S
TAY Mo
de 2
1.
Pres
s and hold the 0 key until two beeps are
heard (Only if no alarm).
Or
2. Enter your code followed by the # key.
[eg. 2580 + #].
Disar
m All Areas
1. Enter your co
de followed by 0 and then the #
key [eg. 2580 + 0 + #].
T
his f
unction allows a code to disarm all areas that
the code is assigned to at the same time without the
need to disarm each area individually.
Isolating Zones
Standard Isolating
1. P
ress the * key twice.
2. Enter the zone number that you want to
isolate fol
lowed by the * key.
Repeat step 2 if more than one zone is
required to be isolated.
3. Press the # k
ey to exit when finished.
Code To Isolate
1. P
ress the * key once.
2. Enter your user code
, followed by the * key .
3.
Enter the zone number that you want to
isolate fol
lowed by the * key.
Repeat step 2 if more than one zone is
required to be isolated.
4.
Press the # k
ey to exit when finished.
Add/Delete RF Devices (Wireless Zones)
Add RF Device
1. Enter the Installer Code followed by 0 and the
# key [eg. 1234 + 0 + #].
2. Enter the Device Number (1 – 16) that you
want to add followed by the # key.
3. Enter the 9-digit RF device ID number
followed by the # key.
Delete RF Device
1.
Enter the Installer Code followed by 0 and the
# key [eg. 1234 + 0 + #].
2.
Enter the Device Number (1 – 16) that you
want to delete followed by the # key.
3.
Press the * key to delete the RF d
evice.
Solution Ultima 880
Quick Reference Guide 5
Bosch Security Systems Pty Limited