The electronic control consists of two modules, fitted in a housing. The
control / power module is connected to the control / display module by
a ribbon cable.
3.5 Function
3.5.1 LEDs
► Programme selection
► Low rinse aid display
► Low salt display
► End of programme
3.5.2 Push buttons / Programme selection
Intensive 70
The programme consists of a prerinse at 50°, wash cycle at 70°, two
intermediate rinse cycles, final rinse at 70° and a drying cycle.
Normal 65
The programme consists of a prerinse, a wash cycle at 65 °, two
intermediate rinses, final rinse at 69 ° and a drying cycle.
ECO 50
The programme consists of a wash cycle at 50°, one intermediate
rinse cycle, final rinse at 66° and a drying cycle.
Gentle 40
The programme consists of a prerinse cycle, a wash cycle at 40°, one
intermediate rinse cycle, final rinse at 55° and a drying cycle.
Quick 35
The programme consists of a wash cycle at 35°, one intermediate
rinse cycle, final rinse at 55° without drying.
Prerinse
The programme consists of a cold rinse only
3.6 Programme reset
Press the S2 and the S4 buttons for 3 seconds while the appliance is
on. Close the door; the pump continues to drain for approx. one
minute. Then close the detergent dispenser to reset the dispenser.
58300000002393_ara_en_a.doc – 31.07.07 Seite 10 von 60
To Next Page
Loading...
