3 OPERATION
The electronic control consists of two modules, fitted in a housing. The
control / power module is connected to the control / display module by
a ribbon cable.
3.1 Function
3.1.1 LEDs
►
►
►
►
Programme selection
Low rinse aid display
Low salt display
2½ -digit display
3.1.2 Push buttons / Programme selection
Timer programming (ZVW)
The timer preselection button is used to delay the programme start by
up to a max. of 19 hours (setting between 0 h – 19 h). The button
must be pressed for at least 1 sec.
Intensive 70
The programme consists of a prerinse at 50°, wash cycle at 70°, two
intermediate rinse cycles, final rinse at 70° and a drying cycle.
auto 55 / 65
Depending on the aqua sensor decision, the programme consists of:
►
►
►
Wash cycle at 50°, one intermediate rinse cycle, final rinse at 65°
and a drying cycle.
Wash cycle at 65°, two intermediate rinse cycles, final rinse at 65°
and a drying cycle.
Prerinse, wash cycle at 55°, one intermediate rinse cycle, final
rinse at 65° and a drying cycle.
ECO 50
The programme consists of a wash cycle at 50°, one intermediate
rinse cycle, final rinse at 65° and a drying cycle. Drying may last
anything up to 45 minutes, depending on the energy label.
Gentle 40
The programme consists of a prerinse cycle, a wash cycle at 40°, one
intermediate rinse cycle, final rinse at 55° and a drying cycle.
Quick 35
The programme consists of a wash cycle at 35°, one intermediate
rinse cycle, final rinse at 55° without drying.
Prerinse
The programme consists of a cold rinse only
58300000002393_ara_en_a.doc – 31.07.07 Seite 5 von 60
To Next Page
Loading...
