4.7 Hinge
Unscrew the outer door, the base, the angle strip and the side panels;
disengage the tension cord from the hinge lever; unscrew the hinge
lever from the inside door; unscrew the hinge plate from the container
frame.
Unscrew the fixing screw which connects the hinge to the base pan;
lever the hinge plate off the frame; pull the hinge up and out; remove
spring clamp;
Two-piece hinge bearing bush:
Open the bearing bush by disengaging the spacer with a screwdriver
(see sketch)
One-piece hinge bearing bush:
Open the bearing bush by bending up the catches with a screwdriver.
When the bearing bush is removed, it must be renewed.
A = Hinge plate E = Tension cord
B = Hinge lever F = Tension spring
C = Bearing bush G = Spacer
D = Spring clamp H = Catches
58300000002393_ara_en_a.doc – 31.07.07 Seite 25 von 60
To Next Page
Loading...
