4.9 Dispenser
The release mechanism is actuated via an actuator. When the
actuator is actuated for the first time, the detergent-dispenser cover is
opened. At the same time the release pawl engages with the
switching core of the rinse-aid lever so that when the actuator is
actuated again, the dosing plunger is lifted off the rinse aid.
Technical specifications:
Rinse-aid filling quantity 120 ml
Setting 1–6 per 1 ml
Detergent capacity max. 45 g
See Actuator for additional technical specifications.
Removal:
Unscrew the outer door. Disconnect the power. Using a screwdriver,
lift the retention plates stamped out of the inner door off the catch
tappets.
Note:
Adjust the retention plates to the middle before installing the dispenser
to ensure that all the catch tappets lock securely.
Before installing the seal, lubricate with washing-up liquid.
A = Dosing plunger D = Magnetic float
B = Switching core E = Reed contact (optional)
C = Actuator F = Optical sensor (optional)
Leave the upper basket in the appliance in order to
remove the dispenser; close the door and then press in
the unlocked dispenser.
Wear protective gloves; risk of cuts.
58300000002393_ara_en_a.doc – 31.07.07 Seite 27 von 60
To Next Page
Loading...
