Starch deposits (see additional information in the general repair
instructions)
Customer complaint Cause Remedial action
Starch deposits on the
utensils
Underdosing of detergent (wrong detergent)
Wrong programme selected
(too weak programme selected)
Appliance connected to hot water, water inlet temperature too
high
Advise customer, use enzyme detergent
Advise customer, select correct programme
Check hot water connection (setpoint: lower than
60 °C), advise customer; if required, connect to
cold water
58300000002393_ara_en_a.doc – 31.07.07 Seite 52 von 60
To Next Page
Loading...
