Bosch SSB1000 TL - Setting the Unit

SSB 6720866942 (2018/06) US
Installation | 13
4.2.2 Setting the Unit
Remove the top and side carboard panels and the plastic lm. Lift the
unit off the shipping skid with a forklift and position it on the oor in the
desired location.

WARNING: When lifting or moving the boiler: do not attempt
to manipulate the boiler using the top corner tripods or any
other component of the boiler.

WARNING: When lifting or moving the boiler with a forklift:
make sure the forks are longer than the boiler size (width or
depth) so that forks stick out as per Fig. 8.
Fig. 8 SSB 800 SA, 1000 SA and 1000 TL Forklift Handling

WARNING: Always keep the boiler in the upright position.
If a crane is required, the boiler must be lifted through bands.

WARNING: When lifting the boiler with crane: use bands,
no chains. Bands must comply with federal, state and local
rules.

WARNING: When lifting the boiler with crane: the bands
must be positioned according to the Fig. 9.
In multiple unit installations, it is important to plan the position of each unit
in advance. Sufcient space for piping connections and future service/
maintenance requirements must also be taken into consideration. All
piping must include ample provisions for expansion.
4”
4”
Fig. 9 SSB 800 SA, 1000 SA and 1000 TL Crane Lifting Handling
The unit must be installed on a concrete at oor, with no gradient in any
direction, to ensure proper condensate and water drainage (see Fig. 10).
Fig. 10 SSB 800 SA, 1000 SA and 1000 TL Installation