_RTER
w ,4
, UR,, 81_
RTER
Ut,I, BE.
nLt
T UR ,_ 0 ,_ ]
E OFFEE J
Ut,I, BE-
sc nLt
TRR_5 II EgI_TRET5
'd,,!, !5 ]
RII_511_G J
]
Draining hot water
TOO HOT J
Rinse out the water tank, fill with fresh water up
to max and re-insert.
Empty the receptacle and place back under the
nozzle.
Set function selector to /!\, position.
Note: The appliance is automatically rinsed. Water
flows at intervals into the receptacle. Wait for the next
message on display (approx. 4 minutes).
Set function selector to _ position.
Note: The appliance is automatically rinsed. Water
flows at intervals into the tray 23. Wait for the next
message on display (approx. 4 minutes).
Empty tray 23 and coffee dreg tray 21.
Clean and dry contacts 25.
Re-insert tray 23 and coffee dreg tray 21.
Wipe splashes off the nozzle and appliance.
Note: The appliance is automatically rinsed.
The descaling process is complete. The illuminated
ring on calc descaling goes out. The appliance is
ready for use again.
The descaling program requires a specific water
temperature before it can start. Ifthe water
temperature is too high, drain hot water first!
Place a receptacle under the nozzle.
Set function selector to /!\, position.
Water runs into the receptacle.
Set function selector to _ position.
The required temperature has been reached.
The descaling process can start.
3O
To Next Page
Loading...
