Introduction
Page 1-2 Tec h 2
THINGS YOU SHOULD KNOW
TECH 2 DISCLAIMER
The Tech 2 is designed for use by trained service personnel only. It has been developed for the sole purpose
of diagnosing and repairing automotive systems with electronic controls and interfaces. Every attempt has
been made to provide complete and accurate technical information based on factory service information
available at the time of publication. However, the right is reserved to make changes at any time without
notice.
FCC COMPLIANCE
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy. If not installed and used in accordance with the instruction manual,
it may cause harmful interference to radio communications. Operation of this equipment in a residential area
is likely to cause harmful interference, in which case the user will be required to correct the interference at
his or her own expense.
CAUTION
CAUTION!
When performing any checks with the engine running in an enclosed space
such as a garage, make sure there is proper ventilation. Never inhale
exhaust gases; they contain carbon monoxide, a colorless, odorless,
extremely dangerous gas that can cause unconsciousness or death.
CAUTION
CAUTION!
To help avoid personal injury, always set the parking brake securely and
block the drive wheels before performing any checks or repairs on the
vehicle.
To Next Page
Loading...
