Introduction
Te ch 2 Page 1-3
VDE CERTIFICATION (FOR EUROPEAN
USE)
This equipment complies with the requirements of VDE 0871/6.78. Improper use or maintenance neglect
may cause unacceptable radio or TV interference.
TAKING THE PRODUCT BACK AND
RECYCLING
Applicable to product that is sold into the European Union, the European Union has passed a directive
called Waste Electrical and Electronic Equipment, or WEEE for short, to ensure that systems are setup
throughout the EU for the collection, treating and recycling of electronic waste.
CAUTION
CAUTION!
The Tech 2 uses parts that can produce arcs or sparks. When used in a
garage environment, the Tech 2 must be located not less than 18 inches
(460 mm) above the floor.
NOTE
• Do NOT clasp battery clips together when connected simultaneously
to the vehicle's 12-volt cigarette lighter or power supply. Reverse
polarity in the vehicle's cigarette lighter may be present. Damage may
occur to the Tech 2 or to the vehicle.
• If power is applied to the Tech 2 and the display remains blank,
reverse polarity in the cigarette lighter may be present. Damage to the
Tech 2 could occur. Do NOT connect the DLC cable to the vehicle.
Verify that the center contact of the vehicle's cigarette lighter has +12
volts and that the outer contact is grounded.
• Turn off the power before inserting or removing the PCMCIA card.
Continual removal and reinsertion of this card is not recommended.
• Align all cards and components carefully before inserting them into
the Tech 2.
• Make sure all cables and adapters are firmly connected before starting
to use the Tech 2.
• Always read the instructions completely before attempting a new
procedure.
• Do not connect the RS-232 and RS-485 ports to a direct phone line.
The Tech 2 was not designed for this method of communication.
• Do not place the Tech 2 so that the tilt stand can make contact with the
vehicle battery terminal as this could short out the battery.
To Next Page
Loading...
