To use the Command Mode:
1. Switch to the Command Mode.
2. Press a softkey to execute the desired command.
The following commands are available:
–
: Load a sequence. In the Status Display, enter the sequence number.
– : Sequence play, pause
– / : Sequence step forward / backward
– : Maximize / restore selected Image pane
– : Close selected Image pane
– : Toggle between Live Mode and Playback Mode
–
: Toggle selected Image pane between Live Mode and instant playback
– / : Show more Image panes / less Image panes
– / : Start /stop alarm recording
– : Audio on / off
– NEXT: Switch to next page
–
/ / / : Trigger a user event (1-4), only available with single Management
Server
–
: Set the default Management Server, only available when you log on to
Operator Client as a user of an Enterprise User Group.
– : Image pane bars on / off
–
: Full-screen on / off
Bosch Video Management System
Using a CCTV keyboard | en 61
Bosch Sicherheitssysteme GmbH Operator's Manual 2013.07 | V1 | Operator Client
To Next Page
Loading...