de Troubleshooting
disturbance Cause and troubleshooting
"E: 36 / -25 / -26" The drain pump is blocked.
▶ → "
Cleaning the drain pump ", page 46
Water pressure is low. No
fix possible.
The filters in the water inlet are blocked.
▶ Clean the filters in the water inlet →
Page 48.
The tap is closed.
▶ Open the faucet.
The water inlet hose is kinked or pinched.
▶ Make sure that the water inlet hose
is not kinked or pinched.
lights up. Temperature is too high.
▶ Wait until the temperature has dropped.
▶ → "
Abort program ", page 40
The water level is too high.
▶ Start the program Pumping out.
Laundry is jammed in the door.
1. Open the door again.
2. Remove jammed laundry.
3. Close the door.
4th To start the program, press Begin /
Reload.
flashes. Door is not closed.
1. Close the door.
2. To start the program, press Begin /
Reload.
All other fault co-malfunction
of.
▶ Call customer service.
→
"Customer service", page 61
Device works
not.
The mains plug of the mains connection cable is not
plugged in.
▶ Connect the device to the mains.
The fuse is defective.
▶ Check the fuse in the fuse box.
Power supply has failed.
▶ Check whether the room lighting or other
Devices in the room work.
Program starts
not.
Start / reload was not pressed.
▶ Press Start / reload.
52
To Next Page
Loading...
