Troubleshooting de
disturbance Cause and troubleshooting
Program starts
not.
Door is not closed.
1. Close the door.
2. To start the program, press Begin /
Reload.
Child lock is activated.
▶ → "
Deactivating childproof lock ", page 41
Completed in is activated.
▶ check if Completed in is activated.
→
"Keys", page 24
Laundry is jammed in the door.
1. Open the door again.
2. Remove jammed laundry.
3. Close the door.
4th To start the program, press Begin /
Reload.
Door cannot be opened - - - is activated.
nen.
▶ Continue the program by pressing Sluice
change or Pumping out choose and Start / reload
gene to press.
→
"Continuing the program at Rinse Hold", page 40
Temperature is too high.
▶ Wait until the temperature has dropped.
▶ → "
Abort program ", page 40
The water level is too high.
▶ Start the program Pumping out.
Power failure.
▶ Open the door with the emergency release.
→
"Emergency release", page 59
The detergent solution does not come out. Drain pipe or water drainage hose is blocked.
pumped out.
▶ Clean the drain pipe and water drain
running hose.
The drain pipe or water drainage hose is kinked or
pinched.
▶ Make sure the drain pipe and the
The water drainage hose is not kinked or trapped.
The drain pump is blocked.
▶ → "
Cleaning the drain pump ", page 46
- - - is activated.
53
To Next Page
Loading...
