de Troubleshooting
disturbance Cause and troubleshooting
change or Pumping out choose and Start / reload
Detergent does not work
pumped out.
▶ Continue the program by pressing Sluice
gene to press.
→
"Continuing the program at Rinse Hold", page 40
The water drainage hose is connected too high.
▶ Mount the water drainage hose in maxi-
times 1 meter in height.
Detergent dosage is too high.
▶ Immediate action: Mix one tablespoon
Softener with 0.5 liters of water and pour the
mixture into the left compartment (not for outdoor,
sportswear and down textiles).
▶ For the next wash cycle, reduce the
load the amount of detergent.
Inadmissible extension mounted on the water
drainage hose.
▶ Remove impermissible extensions from the water
drain hose. Connect device
Water does not run in.
Detergent won't
washed in.
Start / reload was not pressed.
▶ Press Start / reload.
The filters in the water inlet are blocked.
▶ Clean the filters in the water inlet →
Page 48.
The tap is closed.
▶ Open the faucet.
The water inlet hose is kinked or pinched.
▶ Make sure that the water inlet hose
is not kinked or pinched.
Repeated arrival
sling.
The unbalance control system compensates for the unbalance
by distributing the laundry several times.
▶ No mistake - no action required.
Note: When loading, place large and small items of
laundry together in the drum. Laundry items of
different sizes are better distributed during spinning.
Program duration change
changes during the
washing process.
The program sequence is electronically optimized. This can
lead to a change in the duration of the program.
▶ No mistake - no action required.
The unbalance control system compensates for the unbalance
by distributing the laundry several times.
▶ No mistake - no action required.
54
To Next Page
Loading...
