Troubleshooting de
disturbance Cause and troubleshooting
Program duration change
changes during the
Note: When loading, place large and small items of
laundry together in the drum. Laundry items of
different sizes are better distributed during spinning.Washing process.
The foam control system switches on a rinse cycle if the
foam builds up too much.
▶ No mistake - no action required.
Water is not visible
in the drum
bar.
Water is below the visible range.
▶ No mistake - no action required.
▶ Do not fill an additional one during operation
Water into the device.
Drum jerks
Program start.
The cause is an internal motor test.
▶ No mistake - no action required.
In the chamber
there is residual water
ser.
loading The insert in the chamber is blocked.
▶ → "
Cleaning the detergent drawer ", page 44
Vibrations and movement
the appliance during
spinning.
Device is not aligned correctly.
▶ Align the device
The feet of the device are not fixed.
▶ Fix the device feet. Align the device
Transport locks are not removed.
▶ Remove the transport locks
Drum turns,
Water does not run in.
Load detection is active.
▶ No mistake, no action necessary.
Note: The load detection can take up to 2 minutes.
Strong foaming
manure.
Detergent dosage is too high.
▶ Immediate action: Mix one tablespoon
Softener with 0.5 liters of water and pour the
mixture into the left compartment (not for outdoor,
sportswear and down textiles).
▶ For the next wash cycle, reduce the
load the amount of detergent.
High spin speed
number is not
reached.
The low spin speed is set.
▶ Set a higher one for the next wash cycle
Spin speed.
The unbalance control system compensates for unbalance
by reducing the spin speed.
▶ Redistribute the laundry in the drum.
55
To Next Page
Loading...
