24
Selecting the programme
Basic programmes
Select the desired programme - also see the
Programme Chart.
For the maximum spin speed of the
programmes, see Chart S. 27.
Cottons+Linens (Kochwäsche)
y 90°C
Energy intensive programme for heat-
resistant textiles, e.g. made of cotton or
linen.
To protect the wastewater pipes, the hot
wash water is mixed with cold water and
cooled before being drained.
Cottons+Coloureds (Buntwäsche)
y 60°C + ”Intensiv Waschen” button
For stained, heavily soiled textiles, e.g.
cotton or linen.
Energy saving programme. The extended
washing time achieves a cleaning result
comparable to that of the 90°C programme,
but uses considerably less energy.
Cottons+Coloureds (Buntwäsche)
y 60°C + Prewash (Vorwäsche)
For heavily soiled, hard-wearing textiles,
Cottons+Coloureds (Buntwäsche)
y 30, 40, 60°C
For hard-wearing textiles.
Easy Care (Pflegeleicht)
A 30, 40, 60°C
For Easy Care textiles, e.g. made of cotton,
linen, synthetic or blended fabrics
Delicates (Feinwäsche) q 30, 40°C*
For delicate textiles, e.g. made of cotton,
linen, synthetic or blended fabrics.
(e.g. curtains).
No spin between rinse cycles.
Sportswear 40°C*
Programme for textiles with elastane.
Silk (Seide) J 30°C
A special programme at a temperature of
30°C for machine washable silk.
Woollens (Wolle) U cold (kalt), 30°C
For hand- and machine-washable wool or
wool-rich textiles, e.g. cashmere, mohair
or angora.
Woollens / Silk (Wolle/Seide)
U u cold (kalt)**
A special gentle programme for hand and
machine washable silk.
Quick Wash 40°/30 min I
For a load of lightly soiled laundry items up to
2.5 kg. To freshen up cottons, linens, coloureds
or hard-wearing synthetics.
Washing temperature automatically set to
40°C. Time limited to 30 minutes.
For this programme, reduce the
amount of detergent by half!
Additional programme selections
Rinse (Spülen) K
Separate rinse cycle with subsequent spin
for Easy Care textiles.
Spin (Schleudern) B
Separate spin cycle. Wash or rinse water is
pumped out before the spin cycle.
Notes
When choosing ”rinsing” and ”spinning”
programmes, note the appropriate spin
speed, see Chart S. 27.
* Depending upon the model.
**
Programme with very little mechanical
action and without intermediate spin cycle
during the rinse cycles. The programme
ends with a gentle spin at 600 rpm.
To Next Page
Loading...
General