Bosch WAX32KC1FG - Page 53

Troubleshooting NL
Malfunction Cause and Troubleshooting
Detergent residue on
the dry laundry.
▶
When the intelligent dosing is activated, reduce the
basic dosing amount
→ Page 37 .
Insufficient cleaning
next operation.
Basic dosing amount not set correctly.
▶
If the intelligent dosing is activated, set the basic
dosing amount → Page 37 correctly.
Detergent or care agent in the dosing containers of
the intelligent dosing system has thickened.
1. Check whether the detergent used is suitable.
→ "Detergent and laundry care agent",
Page 32
2. Empty the dosing containers.
→ "Cleaning the detergent drawer",
Page 38
3. Clean the dosing containers.
4. Refill the dosing containers.
→ "Filling the dosing container", page 36
Unsuitable detergent has been placed in the dosing
container of the intelligent dosing system.
1. Check whether the detergent used is suitable.
→ "Detergent and laundry care agent",
Page 32
2. Empty the dosing containers.
→ "Cleaning the detergent drawer",
Page 38
3. Clean the dosing containers.
4. Refill the dosing containers.
→ "Filling the dosing container", page 36
At the water supply
feed hose is leaking water.
The water inlet hose is not correctly / firmly
connected.
1. Connect the water supply hose correctly. Connect
water supply hose
2. Tighten the coupling properly.
Water is leaking from
the water drain hose.
Water drain hose is damaged.
▶
Replace the damaged water drain hose.
Water drain hose is not connected correctly.
▶
Connect the water drain hose correctly. Water drainage
connection types
53