NLusage
5.4 Operating logic
The power-on process takes a few
seconds.
Some areas of the display respond to
touch. You activate settings by
pressing the keys. The activated
settings are clearly highlighted on the
display. You can change or deactivate
activated settings by pressing the
corresponding button on the display
again.
2.The program Cleaning the drumSet
up.
3.Close the door.
4.Pull out the detergent drawer.
5.Fill powder detergent into
compartment II.
PAY ATTENTION!
Violent action on the display may
cause damage.
▶ Do not exert strong pressure on
the display.
▶ Do not press on the display with
pointed or sharp objects.
1 2
To avoid foaming, use only half the
amount recommended by the
detergent manufacturer for light
soiling. Do not use wool or delicate
detergent.
6.Slide the detergent drawer into the
appliance.
7.Press
to start the program.
(Start/Pause) to start the
aThe display shows the remaining
program duration.
aAfter the program end, it shows
display: End.
g6
use
Before first use
gB
use
prepare the device for use
8.Start the first wash cycle or press to
switch off the appliance.
→
"The Ministry in Essence",
Page 32
use.
6.1 Starting a wash cycle
without laundry
Your appliance has been thoroughly
checked before leaving the factory.
learned. To remove any residual water
n first time sun
sg
O
wider
there wa
1.Busy
, do you wash the e
ed.
p .
20
To Next Page
Loading...
