NLHome Connect
3.As soon as the appliance is
displayed in the Home Connect
app, follow the last steps in the
Home Connect app.
2.Set program to position 5.
aThe display shows "rES"
to give.
3.on to press.
aWhen the display shows "con"
the appliance is connected to the
Home Connect app.
aThe display shows "YES"
given.
4.on to press.
16.4 Activate WiFi on the device
aThe network settings are
set back.
aIf the displayendshows, are the
network settings reset.
Remark:The energy consumption
increases compared to the values
indicated in the consumption value
tables when Wi-Fi is activated.
16.7 Remote start
Release the appliance for remote start
via the Home Connect app.
1.Approx. 3 s press.
2.Set program to position 4.
Activate remote start
aThe display shows "Con"
given.
Comments
sThe remote start is due to
deactivated for security
reasons under the following
conditions:
– Open the appliance door.
– Press .
– Press .
– Turn off the device.
– After a power outage.
sThe remote start is possible due to
for safety reasons are not activated
when the appliance door is open.
3.Press
displays.
until the display shows "on"
aWiFi is activated.
16.5 Deactivate WiFi on the
device
1.Press for at least 3 seconds.
2.Set program to position 4.
aThe display shows "Con"
given.
Requirements
sThe device is connected to your home WiFi
network connected.
sThe appliance is connected to the Home Con-
net app connected.
sA program has been selected.
3.Press
displays "oFF".
until the display
aWiFi is deactivated.
Remark:The connection is
automatically re-established when Wi-
Fi is re-enabled.
▶ Press .
Pressing the button for at least 3
seconds opens the Home Connect
menu.
When you press the button, the
appliance is enabled for remote
start via the Home Connect app.
16.6 Resetting the device's
network settings
1.Press for at least 3 seconds.
38
To Next Page
Loading...
