NLHome Connect
can be operated via the Home
Connect app, adjust basic settings or
monitor the current operating status.
16.1 Connecting device to
WLAN home network
(WiFi) with WPS function
Remark:More information can be
found in the digital operating
instructions by scanning the QR code
in the table of contents or on
www.bosch-home.com.
Requirements
sYour router has a WPS
function.
sWi-Fi on the router is activated. sThe
basic WiFi setting on the device
rate is activated.
→
"Activate WiFi on the device",
page 38
sThe appliance has
cation reception from the home
network (Wi-Fi).
sThe Home Connect app is on the
mobile terminal installed.
The Home Connect services are not
available in every country. The
availability of the Home Connect
function depends on the availability of
the Home Connect services in your
country. Information on this can be
found at: www.home-connect.com. s→
"Device with WLAN home network
work (WiFi) with WPS function",
page 36
s→
"Device with WLAN home network
work (WiFi) without WPS
function", page 37
The Home Connect app guides you
through the entire registration
process. Follow the instructions in the
Home Connect app to make the
settings.
1.Press for at least 3 seconds.
aThe display shows "Aut"
to give.
2.Press .
3.Press the WPS button on the
router within 2 minutes.
Follow the information in your
router's documentation. a
flashes on the display. aThe device
is connecting
with the home Wi-Fi network. a
When the display shows "con"
is displayed and lights up
permanently, the device is
connected to the home Wi-Fi
network.
Tips
sTake the supplied document
of Home Connect. sAlso take
the directions
the Home Connect app.
Comments
sFollow the safety instructions
ties in this manual and make sure
that they are also observed when
you operate the appliance via the
Home Connect app.
→
"Safety", Page 4
sOperating the device
always takes precedence. During
this time, operation via the Home
Connect app is not possible.
4.If the display shows "Err", the device
is not connected to the home WiFi
network.
s Check if the device is within
range of the Wi-Fi network.
s Reconnect the device to the Wi-
Fi network with WPS function.
5.Connect the appliance to the Home
Connect app. →
Page 37
36
To Next Page
Loading...
