Home ConnectNL
16.2 Connecting device to
WLAN home network
(WiFi) without WPS
function
6.Enter the network name (SSID) and
password (key) of your home
network in the Home Connect app.
7.Follow the steps in the Home
Connect app to connect the
appliance.
If your router does not have WPS
function, you can manually connect the
device to your home network (Wi-Fi).
aWhen the display shows "con"
is displayed and lights up
permanently, the device is
connected to the home Wi-Fi
network.
Requirements
sWi-Fi on the router is activated. sThe
basic WiFi setting on the device
rate is activated.
→
"Activate WiFi on the device",
page 38
sThe appliance has
cation reception from the home
network (Wi-Fi).
sThe Home Connect app is on the
mobile terminal installed.
8.If the display shows "Err", the device
is not connected to the home WiFi
network.
s Check if the device is within
range of the Wi-Fi network.
s Reconnect the device to the Wi-
Fi network with WPS function.
1.Press for at least 3 seconds.
9.Connecting the appliance to the
Home Connect app →
Page 37
.
aThe display shows "Aut"
to give.
16.3 Connecting the appliance
to the Home Connect app
2.Set the program to position 2.
aThe display shows "juice"
given.
3.Press .
Requirements
sThe device is connected to the
WiFi home network.
sThe Home Connect app is open
and you have signed up.
aflashes in the display
aThe device creates its own WiFi
home network with the network
name (SSID) HomeConnect on.
4.Call up the WiFi settings on the
mobile end device.
.
1.Set the program to level 3.
Connect the mobile end device to
the HomeConnect WiFi network and
enter the HomeConnect WiFi
password (key).
aYour mobile end device makes
connection to the device. The
connection procedure can take up
to 60 seconds.
aThe display shows "App"
given.
2.Press .
aThe device is connecting
with the Home Connect app.
5.Open the Home Connect app on
the mobile end device and follow
the steps in the app.
37
To Next Page
Loading...
