EasyManua.ls Logo

Bosch WDU8H541NL - Detergent and Fabric Care Ginger; The Ministry in Its Essence; Switching on the Device; Set Program

Bosch WDU8H541NL
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NLDetergent and laundry care product
13 Detergent and detergent
care product
14.1 Switch on device
Required:The device is correctly set
up and connected.
"Setting up and
connecting", Page 13
Comments
sComprehensive directions for the
Use can be found at www.bosch-
home.com or by scanning the QR
code on the title page of these
instructions for use.
sTake the information regarding Safe-
ness
Page 4
and Avoid material
damage
Page 11
heed.
Press .
The power-on process takes a few
seconds.
Remark:The drum lighting switches
off automatically.
14.2 Set program
Information from the manufacturer about
use and dosage can be found on the
packaging.
1.Turn the program selector and set
it to the desired programme.
"Programs", Page 27
Comments
swith liquid detergents only
tend to use self-flowing liquid
detergents
svarious liquid detergents
don't mix
sdetergent and fabric softener not
to blend
sNot stored for too long and strongly in-
using thickened products. sno
solvent-based, corrosive
using the disinfectants, e.g.
bleach sUse dyes in moderation
salt can affect stainless steel
sno decolorizing agent in the appliance
ready to use
2.If necessary, adjust the program
settings.
14.3 Adjust program settings
Required:A program is set.
"Set program", page 32
Adjust the program settings.
"Buttons", Page 23
Please observe the information on
the subject of operating logic.
Remark:The program settings are not
saved permanently for the program.
B1administration 4 The Operation in es-
sentie
14.4 Save program settings
Service
Remark:More information can be
found in the digital operating
instructions by scanning the QR code
in the table of contents or on
www.bosch-home.com.
You can save your individual program
settings as favourites.
Requirements
sA program is set. sThe program
settings are
amended.
Press for about 3 s.
32

Table of Contents

Related product manuals