First commissioning
The first wash cycle (without laundry)
The first wash cycle should be carried out
without laundry, in order to remove
production-related test water residues.
1. Make sure that the transport lock is located
on the rear panel (see installation
instructions).
2. Open the tap.
3. Pull out the dispenser drawer until it stops.
4. Fill in Chamber II half a measuring cup full
detergent. Do not use fine order wool
detergent, because the foaming is too high.
5. Press the "On / Off" button.
6. Set the program selector to Cottons 60 C.
7. Set the knob to start on the start position.
The program runs.
8. After the end of program, press the "On /
Off" button.
Reminder for water hardness
Insufficient amounts of detergent will depend
on the water hardness. Your local water
company can give you information about the
water hardness.
In the detergent drawer, a reminder of the
water hardness can be set, e.g. 3.
To Next Page
Loading...
