Maintenance / Care / Cleaning
Cleaning the drain pump
Cleaning is necessary:
If the pump is blocked by foreign
bodies (eg. Buttons, brackets) and the
water is not drained.
If lint is present after washing of
textiles.
When the pump is clogged, up to 20 liters of
water may leak. Provide a bucket.
Cleaning process:
1. Remove the plinth at the front panel.
Danger of scalding! Allow hot detergent
solution to cool.
2. Pull breech plug from evacuation tube.
Allow water to leak into the plinth. If
necessary, repeat the process several times.
3 Replace plug seal and insert drainage hose.
4. Remove the pump cover.
5. Remove foreign bodies and deposits of
fluff. Clean the pump interior. Pump impeller
must be able to rotate.
6. Close pump tightly.
7. Re-attach and close plinth.
8. Pour about 2 liters of water into the
detergent chamber I and perform program 7
(pumping). This prevents unused detergent
from flowing in the next wash into the
drainage system.
To Next Page
Loading...
