Maintenance / Care / Cleaning
To clean the filter in the water inlet
The filters in the water inlet must be cleaned
when the water tap is open but no or
insufficient water enters the unit. The
“Prewash” indicator light flashes.
The filters are located in the hose fitting at
the water tap and for appliances without
Aqua-Stop at the back of the unit.
Cleaning process:
1. Close the water tap.
2. Switch on the device, Set program selector
to Easy Care 30, launch and after about 40
seconds, press the "On / Off" button (water
pressure in the inlet hose is removed).
For devices without Aqua-Stop:
3. Unscrew the hose to the water tap, and
rinse strainer under running water.
4. Connect the hose again.
5. Unscrew the hose on the rear side.
6. Pull out, clean and replace screen with a
pair of pliers.
7. Connect the hose again.
8. Turn on the water tap and ensure that no
water leaks out.
9. Turn off the tap.
For appliances with Aqua-Stop:
3. Unscrew hose only at the tap.
4. Pull out, clean and replace screen with a
pair of pliers.
5. Connect the hose again.
6. Turn on the water tap and ensure that no
water leaks out.
To Next Page
Loading...
