Bosch WFF 16 series - Special Programs and Program Change; Soaking and Strengths Programs; Dyeing, Decolorizing, and Program Change

Special programs / Change program
Soaking (program 6)
1. Insert the same color wash only.
2. Fill Chamber I with soak detergent.
Read the information on the
packaging!
3. Press the "On / Off" button.
4. Set program selector to 6.
5. Set knob start to the starting
position.
The program runs
The soak program lasts 2.5 hours. The
soaking liquor is pumped off briefly to
have a washing optimum water level.
Now you have two options:
Use soaking water for
washing.
Set and start the wash
program. No additional
washing can be added.
Or
Fresh water for washing use:
6. A spin program perform.
7. Set After spinning washing
program.
8. Press the “Prewash” button.
9. Fill detergent only in compartment
II.
10. Start the wash program.
Strengths (Program 5)
The washing should not be treated
with fabric softener.
1. Dissolve starching agents in water.
Read the information on the
packaging!
2. Switch on the device.
3. Turn the program selector to
5.
4. Set the knob to start on the start
position.
5. When adding the water, pull the
detergent drawer out slightly and
place starching agent in Chamber II.
6. Close the detergent drawer.
The strength program lasts about 25
minutes and ends with a short gentle
spin.
To dye
Dyeing is possible in your washing
machine with limitations.
Please use only environmentally
friendly dyeing agents. Observe the
manufacturer's instructions for
application and suitability for washing
machines.
A later staining of the laundry by color
deposits on equipment components
cannot be ruled out.
Note: After each dyeing, perform a
boil wash program (90 C) without
laundry. Add 1/2 measuring cup full of
detergent into chamber II.
Decolorize
Decolorizing is not possible in the
device. Discoloring agent may contain
sulfur or chlorine and damage parts.
Change program
If a program has been erroneously set
and started, a change is possible as
follows:
1. Set the program selector to X.
Turn the program start knob to the
end position. The solution is not
drained.
2. Turn the program selector knob to
the new program.
3. Turn the start position knob to
Start.