Fixing minor faults yourself
Washing machine door cannot be opened
Program not yet completed.
Rinse hold selected (see page 16).
Soaking program (see page 18).
After pumping and when the program ends, the
washing machine door can be opened.
When the lamp "Door" is extinguished.
After turning off (about 2 minutes’ wait).
When the "Door" button has been pressed too
early:
Press the door down firmly.
Press the "Door" button.
The Prewash indicator lamp flashes
Is the door closed?
Is the water tap open?
Is the water inlet blocked? (For cleaning, see
page 22)
Is the drain hose, the drain pipe or the drain
pump clogged? (See "Cleaning the drain pump",
page 21).
If everything has been checked:
Set program selector to X and wait until the
display of the rotary knob for the start is in the
final position (see illustration on page 18).
Switch off the machine and wait for 5 seconds.
Set and start the desired program.
If the indicator lamp remains on, there is a
malfunction that must be corrected by the
customer service department.
The indicator light flashes 1 – 7 times after a
short (2 second) pause. The number of blinks is
represents a fault code. They help us, if you
specify the number of blinks after sales service.
To Next Page
Loading...
