Why is my Bosch WGB24400ME Washer not working?
If your Bosch Washer is not working, make sure that the mains plug of the power cord is plugged in. Also, check the circuit breaker in the fuse box and whether there has been a power cut. If these are not the issue, and you suspect a software fault, restart the appliance by pressing and holding for approximately 5 seconds.
What to do if my Bosch WGB24400ME Washer is not draining?
If your Bosch Washer isn't draining water, the drain pipe or water outlet hose might be blocked. Clean the drain pipe and the water outlet hose. Also, the drain pipe or water drain hose might be caught or jammed; ensure that they are not kinked or trapped.
Why won't my Bosch WGB24400ME Washer programme start?
If the programme on your Bosch Washer does not start, ensure that the door is closed properly. Also, check if the childproof lock is activated and deactivate it if necessary. Verify whether the Ready In function is activated. Finally, make sure that no laundry is caught in the door.
Why is my Bosch Washer leaking from the door?
If water is leaking from below the door of your Bosch Washer, it is likely due to dirt on the door or seal. Clean the door and the seal.
What to do if my Bosch WGB24400ME Washer shows error E:30 / -10 and has low water pressure?
If your Bosch Washer displays the error code E:30 / -10 and/or you notice low water pressure, it could be due to several reasons. First, the filter in the water inflow might be blocked, so try cleaning it. Second, the tap might be turned off, so ensure it is on. Third, the water inlet hose could be kinked or jammed, so check and straighten it. If none of these solutions work and the error persists after restarting the appliance, it could indicate a defective water level measurement system, requiring you to call customer service.
How to fix error code E:38 / -25 / -26 on a Bosch WGB24400ME?
If your Bosch Washer displays the error code "E:38 / -25 / -26", the drain pump might be blocked. Also, the inlet opening of the rubber gasket might be blocked. Try cleaning the intake opening in the rubber gasket.
What does error code E:30/-20 mean on my Bosch Washer?
If your Bosch Washer displays "E:30/-20", it might be because the detergent dosage is too high, so reduce the amount of detergent for the next washing cycle with the same load. Also, make sure that you do not add any extra water to the appliance while it is operating. If the issue persists, it may be due to a defective solenoid valve, requiring you to call the after-sales service.
What does H:32 error mean on my Bosch Washer?
If your Bosch Washer displays the error code "H:32", the unbalanced load detection system has interrupted the spin cycle because the laundry is unevenly distributed. Redistribute the laundry in the drum.
What does error E:35 / -10 mean on my Bosch WGB24400ME Washer?
If your Bosch Washer shows error code "E:35 / -10", it could be because there is water in the base trough or the appliance is leaking. Turn off the water tap and call the after-sales service.
Why does the display on my Bosch WGB24400ME Washer go out and flash?
If the display of your Bosch Washer goes out and flashes, it means that the energy-saving mode is active. Press any button to exit the energy-saving mode.
Ensuring correct installation to prevent electrical shock and fire hazards.
Guidelines for safe operation, avoiding risks of electric shock, harm, and suffocation.
Steps for removing packaging and checking for damage before initial setup.
Critical requirements for the installation site to ensure safety and proper functioning.
Guidelines for correctly loading laundry into the drum to prevent creasing and ensure efficiency.
Instructions on how to properly add detergent and care products to the dispenser.
Wash cycle for hard-wearing cotton, linen, or blended fabrics.
Wash cycle for allergy sufferers, meeting strict hygiene requirements.
Steps to install and set up the Home Connect mobile application.
Procedure for connecting the appliance to your home Wi-Fi network.
Troubleshooting steps for when the display is off and the programme indicator flashes.
Troubleshooting steps for error code E:30 / -80 related to blocked drain or hose.
General| Category | Washer |
|---|---|
| Brand | Bosch |
| Model | WGB24400ME |
| Load Type | Front Load |
| Capacity | 9 kg |
| Energy Efficiency Class | A |
| Spin Speed | 1400 rpm |
| Noise Level (Washing/Spinning) | 48 dB / 72 dB |
| Colour | White |
| Delay Start | Yes |
| Child Lock | Yes |
| Type | Washer |
| Dimensions (H x W x D) | 84.8 cm x 59.8 cm x 59.0 cm |
| Programmes | Drum Clean |
| Display | LED |
To Next Page
