Why is my Bosch WGB256090 not working?
Your Bosch washer might not be working because the mains plug of the power cord is not plugged in, so connect the appliance to the power supply. Alternatively, the circuit breaker in the fuse box may have tripped, so check it.
What to do if my Bosch WGB256090 Washer is leaking?
If your Bosch washer is leaking, turn off the water tap and call the after-sales service.
Why is water leaking from below the door of my Bosch WGB256090 Washer?
If water is leaking from below the door of your Bosch washer, it may be caused by dirt on the door or seal. Clean the door and the seal.
How to prevent creasing in my Bosch Washer?
To prevent creasing when using your Bosch washer, set a lower spin speed the next time you run a wash cycle. Also, reduce the amount of laundry being loaded and select the programmes that are suitable for the type of fabric.
What to do if water level is too high in Bosch WGB256090 Washer?
If the water level is too high in your Bosch washer, select a suitable programme for draining.
How to remove detergent residue on damp washing from Bosch WGB256090?
To remove detergent residue on damp washing from your Bosch washer, start the SpĆ¼len programme.
What to do if drain pipe or water drain hose is caught or jammed in Bosch Washer?
If the drain pipe or water drain hose of your Bosch washer is caught or jammed, ensure that the drain pipe and water drain hose are not kinked or trapped.
What to do if my Bosch Washer shows error E:30 / -10?
The E:30 / -10 error code on your Bosch washer indicates that the water pressure is low, the filter in the water inflow is blocked, the tap is turned off, or the water inlet hose is kinked or jammed. Clean the water inflow filter. Turn on the tap. Ensure that the water inlet hose is not kinked or jammed.
Why Bosch WGB256090 Washer high spin speed not reached?
If your Bosch washer isn't reaching high spin speeds, it could be due to a low spin speed being selected, so set a higher spin speed the next time you run a wash cycle. It could also be that the unbalance load detection system is using a reduced spin speed to eliminate an unbalance, so redistribute the laundry in the drum.
What does error E:35 / -10 mean on my Bosch WGB256090 Washer?
Error E:35 / -10 on your Bosch washer indicates there is water in the base trough. Turn off the water tap and call the after-sales service.
To Next Page
General
